REMOTE START
Push the Remote Start button on the key fob twice within five seconds. Pushing the Remote Start
button a third time shuts the engine off.
To drive the vehicle, push the unlock button and cycle the ignition to the ON/RUN position.
With Remote Start, the engine will only run for 15 minutes (timeout) unless the ignition is cycled
to the ON/RUN position.
The vehicle must be cycled to the ON/RUN position after two consecutive timeouts.
WARNING!
• Do not start or run an engine in a closed garage or confined area. Exhaust gas contains
Carbon Monoxide (CO) which is odorless and colorless. Carbon Monoxide is poisonous
and can cause you or others to be severely injured or killed when inhaled.
• Keep key fobs away from children. Operation of the Remote Start System, windows, door
locks or other controls could cause you and others to be severely injured or killed.
KEYLESS ENTER-N-GO — PASSIVE ENTRY
Introduction To Keyless Enter-N-Go
The Keyless Enter-N-Go — Passive Entry system is an enhancement to the vehicle’s key fob. This
feature allows you to lock and unlock the vehicles door(s) and trunk without having to push the
key fob lock or unlock buttons as well as starting and stopping the vehicle with the push of a
button.
To Unlock From The Driver Or Passenger Side:
• With a valid Keyless Enter-N-Go key fob
located outside the vehicle and within 5 ft
(1.5m) of the driver or passenger side door
handle, grab either front door handle to un-
lock the door automatically.
Grab The Door Handle To Unlock
GETTING STARTED
14
To Next Page
Loading...
