In MAX A/C, the blower level and mode position can be adjusted to desired user settings.
Pressing other settings will cause the MAX A/C operation to switch to the prior settings and the
MAX A/C indicator will turn off.
SYNC Temperature Button
• Press the “SYNC” button once to control driver and passenger temperatures simultaneously.
• Press the “SYNC” button a second time to control the temperatures individually.
Air Recirculation
• Use Recirculation for maximum A/C operation.
• For window defogging, turn the Recirculation button off.
• If the Recirculation button is pushed while in the AUTO mode, the indicator light may flash
three times to indicate the cabin air is being controlled automatically. The Recirculation button
will be greyed out in these conditions.
Heated Mirrors
The mirrors are heated to melt frost or ice. This feature is activated whenever you turn on the rear
window defroster.
BLIND SPOT MONITORING
The Blind Spot Monitoring (BSM) system uses two radar sensors, located inside the rear bumper
fascia, to detect Highway licensable vehicles (automobiles, trucks, motorcycles etc.) that enter
the blind spot zones from the rear/front/side of the vehicle.
The BSM detection zone covers approximately one lane width on both sides of the vehicle 12 ft
(3.8 m). The zone length starts at the outside rear view mirror and extends approximately 10 ft
(3 m) beyond the rear bumper of the vehicle. The BSM system monitors the detection zones on
both sides of the vehicle when the vehicle speed reaches approximately 6 mph (10 km/h) or
higher and will alert the driver of vehicles in these areas.
When the vehicle is started, the BSM warning
light will momentarily illuminate in both outside
rear view mirrors to let the driver know that the
system is operational. The BSM system sensors
operate when the vehicle is in any forward gear
or REVERSE and enters stand by mode when
the vehicle is in PARK.
Rear Detection Zones
OPERATING YOUR VEHICLE
61
To Next Page
Loading...
