To Set A Desired Speed
Turn the Electronic Speed Control ON. When the vehicle has reached the desired speed, push
the SET (+) or SET (-) button and release. Release the accelerator and the vehicle will operate at
the selected speed. Once a speed has been set a message CRUISE CONTROL SET TO MPH
(km/h) will appear indicating what speed was set. A CRUISE indicator lamp, along with set speed
will also appear and stay on in the instrument cluster when the speed is set.
To Deactivate
A soft tap on the brake pedal, pushing the CANC button, or normal brake pressure while slowing
the vehicle will deactivate the Electronic Speed Control without erasing the set speed from
memory.
Pushing the on/off button or turning the ignition to the OFF position erases the set speed from
memory.
To Resume Speed
To resume a previously set speed, push the RES (+) button and release. Resume can be used at
any speed above 20 mph (32 km/h).
To Var y The Speed Setting
To Increase Speed
When the Electronic Speed Control is set, you can increase speed by pushing the SET + button.
The driver's preferred units can be selected through the instrument panel settings if equipped.
Refer to “Understanding Your Instrument Panel” in the Owner’s Manual on the DVD for more
information. The speed increment shown is dependant on the chosen speed unit of U.S. (mph) or
Metric (km/h):
U.S. Speed (mph)
• Pushing the SET + button once will result in a 1 mph increase in set speed. Each subsequent tap
of the button results in an increase of 1 mph.
• If the button is continually pushed, the set speed will continue to increase until the button is
released, then the new set speed will be established.
Metric Speed (km/h)
• Pushing the SET + button once will result in a 1 km/h increase in set speed. Each subsequent
tap of the button results in an increase of 1 km/h.
• If the button is continually pushed, the set speed will continue to increase until the button is
released, then the new set speed will be established.
OPERATING YOUR VEHICLE
46
To Next Page
Loading...
