NOTE:
• Whenever an audible alert is requested by the BSM system, the radio volume is reduced.
• If the hazard flashers are on, the system will request the appropriate visual alert only.
When the system is in RCP, the system shall respond with both visual and audible alerts when a
detected object is present. Whenever an audible alert is requested, the radio volume is reduced.
Turn/hazard signal status is ignored; the RCP state always requests the chime.
Blind Spot Alert Off
When the BSM system is turned off there will be no visual or audible alerts from either the BSM
or RCP systems.
NOTE:
The BSM system will store the current operating mode when the vehicle is shut off. Each time the
vehicle is started the previously stored mode will be recalled and used.
COMMANDVIEW SUNROOF WITH POWER
SHADE
The CommandView sunroof with power shade switch is located on the overhead console.
Opening Sunroof
Express Open
Push the switch rearward and release it within
one-half second. The sunroof will fully open
and stop automatically.
Manual Open
Push and hold the switch rearward to open the
sunroof. Any release of the switch will stop the
movement, and the sunroof will remain in a
partially open position until the switch is
pushed again.
Venting Sunroof
Push and release the button and the sunroof
will open to the vent position.
This is called “Express Vent” and will occur
regardless of sunroof position. During Express
Vent operation, any movement of the switch
will stop the sunroof.
Commandview Sunroof Switches
1 — Opening Sunroof
2 — Venting Sunroof
3 — Closing Sunroof
4 — Opening Shade
5 — Closing Shade
OPERATING YOUR VEHICLE
63
To Next Page
Loading...
