(4) Remove push in fasteners attaching the fascia
to upper radiator closure panel.
(5) Pull the sides of the fascia outwards to disen-
gage fascia from drive pins then pull fascia forward.
(6) Disconnect fog lamp wire connectors, if
equipped.
(7) Remove fascia from vehicle.
INSTALLATION
(1) Connect fog lamp wire connectors, if equipped.
(2) Place fascia in position on vehicle, by fitting
foam to bumper beam.
(3) Snap sides of fascia over drive pin fasteners on
fenders.
(4) Install fasteners to upper radiator closure.
(5) Install fasteners attaching fascia to front fend-
ers and splash shields.
(6) Install fasteners attaching bottom of fascia to
lower crossmember.
FRONT BUMPER REINFORCEMENT
REMOVAL
(1) Remove front fascia.
(2) Remove end plugs in ends of bumper after
removing screws in front of bumper.
(3) Remove attaching bolts from bumper reinforce-
ment to adapter plate through ends of the bumper.
(Fig. 8).
(4) If beam is damaged, the adapter plate to rail
welds will have to be cut off
INSTALLATION
(1) Place reinforcement in position on front of vehi-
cle.
(2) Install attaching bolts to inside of bumper rein-
forcement to adapter plates.
(3) Install end plugs in ends of bumper, using
screws in front of the bumper.
(4) Install front fascia.
Fig. 6 Air Dam
1 – AIR DAM
2 – AIR DUCT AIR DAM
Fig. 7 Front Bumper Fascia
1 – FRONT FASCIA
2 – FOG LAMP CONNECTORS
3 – FRONT FENDER
4 – PUSH IN FASTENER
Fig. 8 Front Bumper Reinforcement
1 – END CAP
2 – FRONT BUMPER REINFORCEMENT
3 – END CAP
13 - 4 FRAMES AND BUMPERS LH
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
