(5) Install timing belt. Refer to ENGINE for proce-
dure.
(6) Install accessory drive belts. Refer to procedure
in this section.
(7) Fill cooling system. Refer to Cooling System
Refilling.
WATER OUTLET CONNECTOR—2.7L
REMOVAL
WARNING: DO NOT REMOVE PRESSURE CAP
WITH THE SYSTEM HOT AND UNDER PRESSURE
BECAUSE SERIOUS BURNS FROM COOLANT CAN
OCCUR.
(1) Drain cooling system. Refer to procedure in
this section.
(2) Remove upper intake manifold. Refer to
ENGINE for procedure.
(3) Remove screws attaching heater tube to outlet
connector.
(4) Disengage tube from outlet connector—only
enough for connector removal.
(5) Remove bolts attaching water outlet connector
(Fig. 27).
(6) Remove outlet connector.
INSTALLATION
(1) Clean sealing surfaces. Inspect gaskets for
tears and cuts. Replace as necessary.
(2) Install outlet connector and tighten bolts to 12
N·m (105 in. lbs.) (Fig. 27).
(3) Inspect and replace heater supply tube O-ring
as necessary.
Fig. 25 Water Pump—3.2/3.5L Engine
1 – SCREWS 12 N·m (105 in. lbs.)
2 – WATER PUMP BODY
Fig. 26 Water Pump Body—3.2/3.5L Engine
1 – O-RING
2 – IMPELLER
3 – WATER PUMP BODY
Fig. 27 Water Outlet Connector—Removal and
Installation
1 – BOLT (2)
2 – BOLT (2)
3 – WATER OUTLET CONNECTOR
LH COOLING SYSTEM 7 - 23
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
