LAMP SERVICE
TABLE OF CONTENTS
page page
REMOVAL AND INSTALLATION
HEADLAMP SWITCH ......................15
HEADLAMP DIMMER SWITCH...............15
HEADLAMP ASSEMBLY....................15
HEADLAMP LEVELING MOTOR..............16
FRONT FOG LAMP .......................16
SIDE REPEATER LAMP ....................17
TAIL LAMP ASSEMBLY.....................17
REAR LICENSE PLATE LAMP ...............18
CHMSL LAMP ...........................19
REMOVAL AND INSTALLATION
HEADLAMP SWITCH
Service procedures for the headlamp switch can be
found in Group 8E, Instrument Panel and Gauges.
More information can be found in Group 8W, Wiring
Diagrams.
HEADLAMP DIMMER SWITCH
The headlamp dimmer switch is incorporated into
the multi-function (turn signal) switch. Proper proce-
dures can be found in Group 8J, Turn Signal and
Flashers. More information can be found in Group
8W, Wiring Diagrams.
HEADLAMP ASSEMBLY
REMOVAL
(1) Remove the headlamp sight shield. Remove
pushpins and remove sight shield.
(2) Partially remove the front fascia to gain access
to the headlamp assembly. Refer to Group 13, Frame
and Bumpers for Removal and Installation proce-
dures.
(3) Remove the jackscrews attaching the headlamp
assembly to the body (Fig. 1).
(4) Pull the headlamp assembly out and disconnect
the electrical connectors (Fig. 2).
INSTALLATION
CAUTION: Do not touch the bulb glass with fingers
or other oily surfaces. Reduced bulb life will result.
(1) Reconnect the headlamp assembly electrical
connectors and slide the headlamp assembly back
into the body.
(2) Install the headlamp jackscrews (Fig. 1).
(3) Reinstall the front fascia. Refer to Group 13,
Frame and Bumpers for Removal and Installation
procedures.
(4) Install the headlamp sight shield.
Fig. 1 Headlamp Jackscrews
1 – HEADLAMP JACKSCREWS
Fig. 2 Headlamp Assembly Removal
1 – REMOVE HEADLAMP HOUSING
LH LAMPS 8L - 15
2000 LHS, 300M, CONCORDE AND INTREPID
To Next Page
Loading...
