SPECIFICATIONS
WHEEL ALIGNMENT SPECIFICATIONS
NOTE: All specifications are given in degrees.
NOTE: All wheel alignments are to be set with the
vehicle at curb height. Refer to CURB HEIGHT MEA-
SUREMENT in SERVICE PROCEDURES.
FRONT WHEEL ALIGNMENT PREFERRED SETTING ACCEPTABLE RANGE
CAMBER 0.00° -0.60° to +0.60°
Cross Camber (Maximum Side-To-Side Difference) 0.00° 0.70°
CASTER +3.00° +2.00° to +4.00°
Cross Caster (Maximum Side-To-Side Difference) 0.00° 1.00°
TOTAL TOE* 0.00° −0.20° to +0.20°
REAR WHEEL ALIGNMENT PREFERRED SETTING ACCEPTABLE RANGE
CAMBER −0.20° −0.70° to +0.30°
TOTAL TOE* +0.10° −0.20° to +0.40°
THRUST ANGLE 0.00° -0.15° to +0.15°
NOTE:
*TOTAL TOE is the sum of both the left and right wheel toe settings. TOTAL TOE must be equally split between
each front wheel to ensure the steering wheel is centered after setting toe. Positive (+) is Toe-in, Negative (−) is
Toe-out.
LH SUSPENSION 2 - 9
To Next Page
Loading...
