SIDE REPEATER LAMP
Removal
(1) Insert a small flat screwdriver between the
lamp and the body panel. Disengage the lamp retain-
ing tabs (Fig. 6) (Fig. 5).
(2) Pull lamp from fender.
(3) Twist bulb socket 1/4 turn and separate the
bulb socket from the lamp (Fig. 7).
Installation
(1) Position the socket in the lamp and twist the
socket 1/4 turn.
(2) Position the lamp into the body opening and
push into place.
TAIL LAMP ASSEMBLY
Removal
(1) Release the deck lid latch and open the deck
lid.
(2) Remove the tail lamp assembly attaching nuts
(Fig. 8).
Fig. 5 Side Repeater Lamp
1 – SIDE REPEATER LAMP
2 – FENDER
Fig. 6 Side Repeater Lamp Retaining Tabs
1 – RETAINING TABS
2 – REPEATER LAMP
3 – FENDER
Fig. 7 Side Repeater Lamp Socket
1 – BULB SOCKET
2 – REPEATER LAMP
Fig. 8 Tail Lamp Assembly Fasteners
1 – TAIL LAMP ASSEMBLY FASTENERS
LH LAMPS 8L - 17
REMOVAL AND INSTALLATION (Continued)
2000 LHS, 300M, CONCORDE AND INTREPID
To Next Page
Loading...
