Chrysler Concorde - Page 1212

only shift out of PARK with the brake pedal being
depressed.
(7) Install the lower shroud (Fig. 69) on the steer-
ing column. Install and securely tighten the 2 screws
attaching the lower shroud to the steering column.
(8) Install the tilt lever (Fig. 68) on the steering
column.
(9) Install the upper shroud on the steering col-
umn by snapping it onto the lower shroud.
(10) Install the lower instrument panel cover.
(11) Install the two screws behind the fuse panel
cover attaching the lower instrument panel cover to
the instrument panel (Fig. 67).
(12) Install the fuse panel cover on the left end of
the instrument panel (Fig. 66).
BRAKE/TRANSMISSION SHIFT INTERLOCK
CABLE (FLOOR)
REMOVAL
(1) Using suitable size allen wrench, remove the
gearshift knob retaining screw (Fig. 75).
(2) Remove gearshift knob from shifter assy.
(3) Remove console bezel from vehicle.
(4) Remove under panel silencer/duct assembly
(Fig. 76).
(5) Remove column cover screws (Fig. 77).
(6) Tilt column down and remove upper half of col-
umn cover (Fig. 78).
(7) Tilt the column to the uppermost position and
remove the tilt lever (Fig. 79).
(8) Remove the ignition key and remove lower col-
umn cover (Fig. 80).
(9) Remove the interlock cable from the shifter
housing. Slide the cable out of the groove in the
interlock lever (Fig. 81).
(10) Disconnect the BTSI solenoid connector.
(11) Depress the lock tab (Fig. 82) on the interlock
cable and pull the cable out of the lock cylinder hous-
ing (Fig. 83).
(12) Remove interlock cable. Note cable routing so
it can be installed in the same manner.
INSTALLATION
(1) Ensure ignition switch is in the “ON/RUN”
position (Fig. 84).
(2) Route the interlock cable into position as previ-
ously removed.
(3) Slide the steering column end of the interlock
cable into the lock cylinder housing until it snaps
into place (Fig. 83).
(4) Connect BTSI solenoid connector.
Fig. 75 Shift Handle Retaining Screw
1 – GEARSHIFT KNOB
2 – HEX WRENCH
Fig. 76 Panel Removal/Installation
1 – SILENCER/DUCT ASSEMBLY
Fig. 77 Lower Column Cover Screw Removal/
Installation
1 – LOWER COLUMN COVER
2 – STEERING WHEEL
LH 42LE TRANSAXLE 21 - 43
REMOVAL AND INSTALLATION (Continued)