FLOOR CONSOLE SHIFT BEZEL
REMOVAL
NOTE: The Transmission Range Indicator Lamp
(electroluminescent) is not serviceable. Replace
Floor Console Panel for replacement of the lamp.
(1) Place gear selector in neutral.
(2) Loosen set screw attaching gear shift knob to
gear shift.
(3) Remove gear shift knob from gear shift.
(4) Disengage clips attaching bezel to floor console
(Fig. 83), or (Fig. 84).
(5) Disconnect the ash tray light and power outlet,
if equipped.
(6) Disconnect the transmission range indicator
illumination connector.
(7) Remove bezel from vehicle.
INSTALLATION
(1) Connect the transmission range indicator illu-
mination connector.
(2) Connect ash tray light, if equipped.
(3) Place bezel in position on vehicle.
(4) Engage clips attaching bezel to floor console.
(5) Push gear shift knob onto gear shift.
(6) Tighten set screw attaching gear shift knob to
gear shift.
FLOOR CONSOLE CUP HOLDER ASSEMBLY
REMOVAL
(1) Remove shift knob.
(2) Remove floor console shift bezel (Fig. 83), or
(Fig. 84).
(3) Raise console armrest lid.
(4) Remove screws at top and bottom of cup holder
assembly (Fig. 85).
(5) Lift up and forward to remove assembly.
INSTALLATION
(1) Place cup holder into floor console and align
screw holes.
(2) Install upper and lower screws.
(3) Lower console armrest lid.
(4) Install floor console shift bezel.
(5) Install shift knob.
FRONT FLOOR CONSOLE PANEL – CONCORDE
REMOVAL
(1) Remove shift knob.
(2) Remove floor console shift bezel (Fig. 83).
Fig. 83 Floor Console Bezel – Concorde
1 – INSTRUMENT PANEL
2 – FLOOR CONSOLE SHIFT BEZEL
3 – TRANSMISSION RANGE INDICATOR ILLUMINATION
CONNECTORS
4 – REAR BEZEL
5 – FLOOR CONSOLE
LH BODY 23 - 69
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
