Use this QR code to access your digital
experience.
BASE INSTRUMENT CLUSTER
DESCRIPTIONS
1. Tachometer
○
Indicates the engine speed in revolutions per
minute (RPM x 1000).
2. Instrument Cluster Display
○
When the appropriate conditions exist, this dis-
play shows the instrument cluster display mes-
sages
page 60.
3. Speedometer
○
Indicates vehicle speed.
4. Temperature Gauge
○
The temperature gauge shows engine coolant
temperature. Any reading within the normal
range indicates that the engine cooling system
is operating satisfactorily.
○
The gauge can indicate a higher temperature
when driving in hot weather or up mountain
grades. It should not be allowed to exceed the
upper limits of the normal operating range.
WARNING!
A hot engine cooling system is dangerous. You or oth-
ers could be badly burned by steam or boiling cool-
ant. You may want to call an authorized dealer for
service if your vehicle overheats
page 186.
CAUTION!
Driving with a hot engine cooling system could dam-
age your vehicle. If the temperature gauge reaches
“H” pull over and stop the vehicle. Idle the vehicle
with the air conditioner turned off until the gauge
drops back into the normal range and is no longer
red. If the gauge remains on the “H”, turn the engine
off immediately and call an authorized dealer for
service.
5. Fuel Gauge
○
The gauge shows the level of fuel in the fuel
tank when the ignition switch is in the ON/RUN
position.
○
The fuel pump symbol points to the
side of the vehicle where the fuel
door is located.
NOTE:
The warning/indicator lights will illuminate for a bulb
check when the ignition is first cycled.
Scan me
58 GETTING TO KNOW YOUR INSTRUMENT PANEL
To Next Page
Loading...
