29
Other
Test Mode
Under test mode, if you trigger any sensors, the system will not sound the alarm but
give out 3 beeps. You can quit this mode once you nish the testing.
Network Conguration
This setting enables you to connect your device to another WiFi network without
having to repeat the original setup process.
Firmware Update
This setting enables you to update your panel to the latest rmware when available.
Keep your hub plugged in while updating. Do not disconnect or turn off your hub as
doing so will cause serious damage.
Tap on Firmware Update, a blinking red light indicates your unit is updating.
To Next Page
Loading...
