Chuango H4-LTE - Alarm System Operation; Arming the System; Sensor Triggering and Alerts

03
How the Alarm System Works
Arm the system
using the remote
control or the App.
The Hub receives the
command and enters
“Armed” mode.
When a Door/Window
Sensor detects a door/
window opening, the sensor
sends a signal to the Hub
letting the Hub know there
has been an intrusion.
The Hub sends a push notication
and text message to your phone.
You will also receive an email
when a sensor is triggered if you
enable the notication function
located in your app settings. After
that the hub will also make phone
calls to each pre-set phone
numbers.
The Hub sounds at 90dB
on-site.
The Hub is set to Arm
Mode (The red Status
Indicator is on) .