Need help?Do you have a question about the Chuango H4 PLUS and is the answer not in the manual?
Power| power supply voltage | DC 12V |
|---|---|
| power supply current | 500mA |
| battery voltage | 3.7V |
| battery capacity | 2600mAh |
Operating Environment| operating temperature range | 0°C ~ +55°C |
|---|---|
| relative humidity | <80% (Non-condensing) |
Dimensions| hub dimensions | 160 x 160 x 45mm |
|---|---|
| bracket dimensions | 80 x 80 x 10mm |
Power| power supply voltage | DC 3V |
|---|---|
| transmit current | <7mA |
Operating Environment| operating temperature range | 0°C~+55°C |
|---|---|
| relative humidity | <80% (Non-condensing) |
Dimensions| dimensions | 58 x 31 x 9.5mm |
|---|
Power| power supply voltage | DC 1.5V |
|---|---|
| static current | <35uA |
| alarm current | <40mA |
Operating Environment| operating temperature range | 0°C~+55°C |
|---|---|
| relative humidity | <80% (Non-condensing) |
Dimensions| transmitter dimensions | 71 x 34 x 17.5mm |
|---|---|
| magnet dimensions | 51 x 12 x 13.5mm |
Power| power supply voltage | DC 3V |
|---|---|
| static current | <18uA |
| alarm current | <12mA |
Operating Environment| operating temperature range | 0°C~+55°C |
|---|---|
| relative humidity | <80% (Non-condensing) |
Dimensions| sensor dimensions | 108 x 52 x 36.8mm |
|---|---|
| bracket dimensions | 52 x 30 x 26.5mm |
Guidance on placing the hub for optimal WiFi signal and network speed requirements for hub performance.
Explains the meaning of different statuses (blinking, yellow, white) for the WiFi indicator light.
Details the meaning of various colors and patterns (blue, green, red, off) for the status indicator light.
Explains the pet immunity feature and the detector's testing and power-saving modes.
Steps to connect the hub to your WiFi network, including router band requirements.
Details on connecting the hub to your smartphone's WiFi and entering network credentials.
Details requirements for cellular connection: SIM card type, AC adapter, and power switch.
Explains scenarios for cellular use: backup to WiFi or primary connection without WiFi.
Detailed explanation of System Armed, Home Mode, System Disarmed, and SOS Mode.
Configuration for tamper notifications and RF interference detection for enhanced security.
Storing phone numbers for SMS/call alerts and how the hub makes calls during alarms.
List of phone keypad commands to remotely control the system during an incoming call.
Procedure for updating the hub's firmware to the latest version for optimal performance.
Advice on optimal placement of the hub for the best signal, avoiding specific locations.
Steps for testing and installing door/window sensors, including placement and securing with tape.
Guidance on choosing a suitable location and mounting the PIR motion detector on a wall.
Instructions for testing the detector's motion detection and adjusting its angle for optimal performance.
Procedure to restore the hub to its factory default settings using the pairing button.
To Next Page
