Chuango H4 PLUS User Manual

19
System Statuses
System Armed
In this mode, all of the sensors are on alert; the hub’s built-in siren will sound when
a sensor is triggered. You and ALL other pre-authorized users will receive push
notications, SMS and phone calls (if phone numbers have been stored).
This mode is recommended to use when no one is at home, it can be easily set from
the remote control or App.
System in Home Mode (Partial Arm or Stay Mode)
Only Home Zone sensors will stop detecting under this mode, which enables you and
your family to move freely inside your home without accidentally triggering an alarm.
This mode is recommended when someone is at home, such as during the night, and
can be easily set from the remote control or App.
Note: The Door/window sensor in this kit has been set to Normal Zone by default
and the Motion Detector has been set to Home Zone, you can refer to page (25) and
change their zone mode on the “Accessory Settings” page of the App.
System Disarmed
All the sensors stop detecting except any sensors that you may have set to 24-Hour
Zone. 24-Hour Zone sensors will continuously monitor a particular area. For example,
an extra water sensor (Set to 24-Hour Zone by default) that has been paired with
Hub and installed near a washing machine would trigger alarm if water is detected,
regardless of system status.
System in SOS Mode
In this mode, the hub’s built-in siren sounds to alert. You and ALL other pre-
authorized users will receive notications.

Chuango H4 PLUS Specifications