12
.
□ Cell Unions installed and glued into pipe work.
□ Threaded Collars on either side of the Cell are hand tight.
□ Flow Switch is installed and oriented properly.
□ Control Module is affixed to wall and wired correctly.
□ Cell Cable and Flow Switch are connected to Control Module.
□ You have checked and confirmed that Control Module switches
ON and OFF concurrently with filter pump, or is energized
continuously for use with variable speed pump.
□ You have checked all connections and joints for leaks.
□ Sufficient salt has been added and fully dissolved and circulated
throughout pool water.
□ Pool has properly balanced water chemistry.
How it works
The RJ PLUS Series chlorine generator, by electrolysis, creates chlorine
to sanitize your pool from the salt molecules (NaCL) in your water. A
small electric charge is applied across a set of titanium plates inside the
Electrolytic Cell. This produces Sodium Hypochlorite (NaOCl). In water,
Sodium Hypochlorite dissociates into sodium (NA+) and hypochlorite
(OCl-) ions.
It is the hypochlorite ions that form with the hydrogen (H+) ions (from
the water) to form hypochlorous acid (HOCl), which is the active agent
that destroys bacteria and algae, and oxidizes organic matter. This form
of chlorine works quickly in the pipe, leaving only a mild residual in the
pool. In addition, the Electrolytic Cell continuously “shocks” the
incoming water- burning off any oils, organic matter, or other particles
that need to be oxidized.
Best of all, the process continuously recycles the salt: after cleaning the
pool, the original molecules reform and the whole process begins again.
The salt doesn't get used up!
To Next Page
Loading...
