6
Refer to the overview diagram on page 4 for alternate configurations.
For combined pool and spa systems with a spillover, configurations #2
or #3 allow chlorination for both the pool and spa during spillover but
preventing possible over-chlorination when operating the spa only.
Vertical Installation Kits are also available to minimize plumbing space
required and increase ease of installation (sold separately, available at
www.circupool.com).
TIP: Double-check that all Cell and Flow Switch cables can reach the
Control Panel.
Note: For installations with 1 ½" plumbing, use 2" to 1 ½" reducer
bushings with flow switch, and use alternate 1 ½" Cell Unions; be sure
to note any new or additional measurements before cutting pipe.
After determining the section of plumbing to install the Flow Switch and
Cell, measure out and mark the selected area.
1. To install the Flow Switch, cut out a section of pipe at the desired
installation location. Use PVC Primer to clean and prepare the pipe
ends and interior of Flow Switch. Using plumbing Solvent Cement,
glue the Flow Switch to the pipe ends. Ensure excess glue does not
become affixed to movable parts within Flow Switch. IMPORTANT:
To insure proper operation, verify that the arrow on the flow switch
(located on the black plastic) points in the direction of water flow;
the water flow must depress the hinged activator inside of the Flow
Switch. This portion is threaded and may be turned during service;
additional thread seal tape may be added if necessary.
2. To install the Cell Unions, cut out a section of pipe at the desired
installation location. Clean parts and plumbing with PVC Primer to
prepare the pipe ends and interior of Unions. Place the Threaded
Collars over the pipe ends. Using plumbing Solvent Cement, glue
one Union to the pipe end.
To Next Page
Loading...
