□ Cell housing installed and glued into pipe work.
□ O-Ring seated in Cell Housing, Cell aligned with and inserted into Cell
Housing, and Cell Cap screwed in place hand tight (Do not use wrench).
□ Control Module is affixed to wall and wired correctly.
□ Cell cable connected to Control Module.
□ You have checked and confirmed that Control Module switches ON
and OFF concurrently with filter pump (or when used with variable
speed pumps is only energized during high water flow.)
□ You have checked all connections and joints for leaks.
□ Sufficient salt has been added and fully dissolved and circulated
throughout pool water.
□ Pool has properly balanced water chemistry.
To Next Page
Loading...
