3. DEVICE INSTALLATION
3.1.- PRIOR RECOMMENDATIONS
In order to use the unit safely, it is critical that those who handle it follow the safety
measures set out in the standards of the country where it is being used, use the neces-
sary personal protective equipment and pay attention to the various warnings indicated
in this instruction manual.
The REC4 device must be installed by authorised and qualified staff.
Also, it is critical to keep the cables in perfect condition in order to avoid accidents, personal injury and
damage to installations.
The manufacturer of the device is not responsible for any damages resulting from failure by the user
or installer to heed the warnings and/or recommendations set out in this manual, nor for damages
resulting from the use of non-original products or accessories or those made by other manufacturers.
If you detect any operational faults in the device or in its protection system, remove the device from
service.
This device has been designed for easy replacement in case of malfunction.
Disable the automatic reclosing function and disconnect the main protection device
before handling active parts.
Please contact the after-sales service if you suspect that there is an operational fault
in the device.
3.2.- INSTALLATION
Do not use the device until it is fully installed.
The REC4 is a device specifically designed to be installed in electric panels or enclosures, with DIN rail
fixing elements (IEC 60715).
To install the device on a DIN rail:
1.- Place the device at the top of the DIN rail.
2.- Swing the REC4 downwards until it is secured to the lower section of the DIN rail.
3.- Make sure that it has been secured on the rail.
8
REC4
Instruction Manual
To Next Page
Loading...
Need help?
General