Cirrus SR20 - Page 125

Cirrus Design Section 4
SR20 Normal Procedures
P/N 21399-004 4-11P/N 21399-004 4-11
6. Power Lever........................................................FULL FORWARD
7. Fuel Pump .................................................... PRIME, then BOOST
• Note •
On first start of the day, especially under cool ambient
conditions, holding Fuel Pump switch to PRIME for 2 seconds
will improve starting.
8. Propeller Area..................................................................... CLEAR
9. Power Lever ........................................................... OPEN ¼ INCH
10. Ignition Switch....................... START (Release after engine starts)
• Caution •
Limit cranking to intervals of 10 seconds with a 20 second
cooling period between cranks. This will improve battery and
contactor life.
11. Power Lever...............................RETARD (to maintain 1000 RPM)
12. Fuel Pump ...............................................................................OFF
13. Oil Pressure ....................................................................... CHECK
14. Alt Master Switches ...................................................................ON
15. Avionics Power Switch...............................................................ON
16. Engine Parameters ........................................................ MONITOR
17. External Power (If applicable)................................. DISCONNECT
18. Amp Meter/Indication......................................................... CHECK
Revision A1