3-8 P/N 21399-004
Section 3 Cirrus Design
Emergency Procedures SR20
Engine Failure In Flight
1. Best Glide Speed ....................................................... ESTABLISH
2. Mixture ................................................................... AS REQUIRED
3. Fuel Selector........................................................SWITCH TANKS
4. Fuel Pump.......................................................................... BOOST
5. Alternate Induction Air............................................................... ON
6. Air Conditioner (if installed)......................................................OFF
7. Ignition Switch........................................................ CHECK, BOTH
If engine does not start:
8.
Perform Engine Airstart or Emergency Landing Without Engine
Power checklist, as required.
Amplification
• WARNING •
If engine failure is accompanied by fuel fumes in the cockpit,
or if internal engine damage is suspected, move Mixture
Control to CUTOFF and do not attempt a restart.
If the engine fails at altitude, pitch as necessary to establish best glide
speed. While gliding toward a suitable landing area, attempt to identify
the cause of the failure and correct it. If altitude or terrain does not
permit a safe landing, CAPS deployment may be required. Refer to
Section 10, Cirrus Airframe Parachute System (CAPS) for CAPS
deployment scenarios and landing considerations.
Reissue A
To Next Page
Loading...
