4-6 P/N 13772-004
Section 4 Cirrus Design
Normal Procedures SR22
3. Empennage
a. Tiedown Rope............................................................. Remove
b. Horizontal and Vertical Stabilizers .............................Condition
• Note •
Verify tape covering the forward and aft inspection holes
located on outboard ends of horizontal stabilizer is installed
and securely attached.
c. Elevator and Tab............................... Condition and Movement
d. Rudder..................................................Freedom of Movement
e. Rudder Trim Tab ...................................Condition and Security
f. Attachment hinges, bolts and cotter pins...................... Secure
4. Right Fuselage
a. Static Button ..............................................Check for Blockage
b. Wing/Fuselage Fairings..................................................Check
c. Door Lock ...................................................................... Unlock
5. Right Wing Trailing Edge
a. Flap and Rub Strips (if installed)...........Condition and Security
b. Aileron and Tab................................. Condition and Movement
c. Aileron Gap Seal .........................................................Security
d. Hinges, actuation arm, bolts, and cotter pins ............... Secure
6. Right Wing Tip
a. Tip...........................................................................Attachment
b. Strobe, Nav Light and Lens ..................Condition and Security
c. Fuel Vent (underside) ......................................... Unobstructed
7. Right Wing Forward and Main Gear
a. Leading Edge and Stall Strips....................................Condition
b. Fuel Cap .......................................Check Quantity and Secure
c. Fuel Drains (2 underside) ............................ Drain and Sample
d. Wheel Fairings...................... Security, Accumulation of Debris
e. Tire.............................................Condition, Inflation, and Wear
(Continued on following page)
Original Issue
To Next Page
Loading...
