Cirrus Design Section 7
SR22 Systems Description
P/N 13772-004 7-33P/N 13772-004 7-33
installed using the center seat belt. Three top tether anchors for the
child seats are located on the rear bulkhead.
To install a child seat:
1. Fasten lower seat attachments to bench seat:
a. LATCH Compliant Outboard Seat: Fasten lower seat
attachment to the outboard anchors in the bench seat.
b. Non-LATCH Compliant Center Seat: Using the center seat
belt, fasten lower seat attachments to the bench seat as
described by the manufacturer's instructions
2. Locate top tether pass-through - a narrow slit in the seat back
upholstery - near the top, outboard section of the seat back.
• Caution •
Do not route child seat top tether over or around seat back.
The top tether must be routed through the seat back pass-
through for the child seat to function properly.
3. Route child seat’s top tether through the seat back pass-through.
4. Fasten top tether to rear bulkhead anchor.
5. Firmly tension the child seat straps according to the
manufacturer's instructions.
Revision 1
To Next Page
Loading...
