3-6 P/N 23020-002
Cirrus SR20 and SR22 Flight Operations Manual
Section 3 Standard Operating Procedures
g. Flap Position Light ............................................................ OUT
Verify flap position light is not illuminated to ensure isolation
diode is functioning properly.
h. Bat 1 Master Switch............................................................ ON
i. Lights ............................................................. Check Operation
Verify operation of required interior (overhead, instrument and
panel lights) and exterior (navigation, landing and anti-
collision lights).
j. Stall Warning ..................................................................... Test
Test stall warning system by applying suction to the stall
warning system inlet and noting the warning horn sounds.
k. Fuel Quantity ..................................................................Check
Ensure fuel quantity is sufficient for planned flight and
corresponds to fuel amount in tanks and on MFD.
l. Fuel Selector ..............................................Select Fullest Tank
Switch fuel selector to the fullest tank. Maximum fuel
imbalance: 7.5 (SR20), 10 gal (SR22).
m. Flaps...................................................100%, Check Lights ON
Visually verify down and ensure light corresponds with flap
setting.
n. Oil Annunciator ................................................................... ON
o. Bat 1 and 2 Master Switches.............................................OFF
Ensure both battery switches are turned off.
p. Alternate Static Source............................................. NORMAL
Visually verify alternate static source located near pilot's right
knee, above circuit breaker panel is in the NORMAL position.
q. Circuit Breakers .................................................................... IN
Ensure all circuit breakers are in and none are in re-settable
(tripped) condition.
r. Fire Extinguisher...................................Charged and Available
Inspect extinguisher and ensure pin and safety wire are in
tact. There is no gauge to measure quantity.
June 2008
To Next Page
Loading...
