Cirrus SR22T Maintenance Manual

CIRRUS AIRPLANE MAINTENANCE MANUAL MODELS SR22 AND SR22T
24-30
Page 33
Serials w/ MCU 19800-001
EFFECTIVITY:
G. MCU Cover - Serials w/ MCU 19800-001 (See Figure 24-307)
(1) Removal - MCU Cover
(a) Set BAT 1, BAT 2, and AVIONICS switches to OFF positions.
(b) Remove engine cowling. (Refer to 71-10)
(c) Disconnect battery 1. (Refer to 24-30)
(d) Remove screws securing MCU cover to chassis. Remove MCU cover.
(2) Installation - MCU Cover
(a) Acquire necessary tools, equipment, and supplies.
(b) Apply corrosion inhibitor as follows:
1
Cover surrounding components and structures to prevent inadvertent application of
corrosion inhibitor to these areas.
2
Apply a thin coat of corrosion inhibitor to MCU circuit board, internal components,
and connectors per the manufacturer’s instructions.
(c) Position MCU cover to chassis and secure with screws.
(d) Connect battery 1. (Refer to 24-30)
(e) Install engine cowling. (Refer to 71-10)
Description P/N or Spec. Supplier Purpose
Corrosion Inhibitor
(aerosol)
MIL-C-81309
Type III
Any Source Prevent corrosion.
01 Jan 2012

Cirrus SR22T Specifications

General

Manufacturer	Cirrus Aircraft
Engine	Continental TSIO-550-K
Horsepower	315 hp
Max Takeoff Weight	3, 600 lbs
Service Ceiling	25, 000 ft
Cabin Width	49 in
Cabin Height	50 in
Seating Capacity	4
Avionics	Cirrus Perspective+ by Garmin
Category	Single-engine piston aircraft
Propeller	Hartzell 3-blade composite
Wingspan	38 ft 4 in
Length	26 ft
Height	8 ft 11 in
Maximum Cruise Speed	213 KTAS
Fuel Capacity	92 gallons
Stall Speed	64 knots
Safety Features	Cirrus Airframe Parachute System (CAPS)
Cruise Speed	183 knots