Section 1: SVP Cisco Wireless LAN Controllers with 1100, 1130, 1140, 1200, 1230, 1240, 1250 APs
PN: 1725-36192-001_H 11
2. In the navigation pane, click Interfaces. Verify that the proper IP
addresses are assigned to the interfaces.
3. Under Interface Name click management.
4. Under DHCP Information, enter the IP address of the Primary DHCP
Server.
5. Repeat this step for the ap-manager interface.
6. Click the Apply button and save the changes.
AP Configuration
All handsets operating on a given AP radio must have the same
QoS setting. All APs supporting the handsets must be configured to
enable the corresponding features.
1. Power-on and connect the APs to the network. Wait a few minutes
for the APs to find the controller.
2. Verify the APs are associated to the WLC.
3. From the main menu, click Monitor.
To Next Page
Loading...
