VIEW Certified Configuration Guide
PN: 1725-36192-001_H
12. Reboot the Controller.
Controller Setup
The initial setup of the controller is shown below.
The setup instructions outlined in this document are for the
configuration shown in the diagram only. Your configuration may
differ, and the appropriate adjustments must be made.
It is not necessary to configure each AP individually. The WLC is
capable of provisioning the APs.
1. From the main menu, click Controller.
2. Set the Ethernet Multicast Mode to Multicast and enter a multicast IP
address that is currently not being used on your network for the
Multicast Group Address.
3. Click the Apply button.
4. Click Save Configuration.
To Next Page
Loading...
