Cisco 1700 series Configuring

27
Configuring an ADSL WAN Interface Card on Cisco 1700 Series Routers
OL-3317-03
Configuring Quality of Service Parameters
Configuration Example
The following example shows a Cisco 1760 router configured with MLP Bundling:
!
interface Multilink1
ip address 10.0.0.9 255.255.0.0
load-interval 30
keepalive 1
max-reserved-bandwidth 100
service-policy output CISCO
no cdp enable
ppp multilink
ppp multilink fragment-delay 10
ppp multilink interleave
multilink-group 1
!
interface ATM0/0
no ip address
no atm ilmi-keepalive
pvc 0/38
vbr-rt 192 192 1000
tx-ring-limit 2
protocol ppp Virtual-Template1
!
dsl operating-mode auto
no shut
!
!
interface ATM1/0
no ip address
no atm ilmi-keepalive
pvc pvc 6/65
vbr-rt 192 192 1000
tx-ring-limit 2
protocol ppp Virtual-Template1
!
!
dsl operating-mode auto
no shut
!
!
!
interface Virtual-Template1
no ip address
load-interval 30
keepalive 1
ppp multilink
ppp multilink multiclass
multilink-group 1
!
For information on how to verify and troubleshoot MLP Bundling, please refer to Enhanced Voice and
QoS for ADSL and G.SHDSL on Cisco 1700 Series, Cisco 2600 Series, and Cisco 3600 Series Routers.

Cisco 1700 series Specifications

General

Model	1700 Series
Connectivity Technology	Wired
Remote Management Protocol	SNMP, Telnet, HTTP
Encryption Algorithm	DES, 3DES, AES
Processor	Motorola MPC860
QoS Support	Yes
Operating System	Cisco IOS
Routing Protocols	OSPF, EIGRP, BGP
Security Features	Firewall, VPN
Memory	16 MB
Expansion Slots	1 x WIC
Data Link Protocol	Ethernet, Fast Ethernet
Network / Transport Protocol	TCP/IP
Features	DHCP, NAT, VLAN
LAN Ports	4 x 10/100Base-TX