4-7
Cisco 1800 Series Routers (Modular) Hardware Installation Guide
OL-5876-03
Chapter 4 Chassis Installation Procedures for Cisco 1800 Series Routers (Modular)
Setting Up the Chassis
To mount the router on a wall or other surface, follow these steps:
Step 1 Install the two screws 6.00 in. (15.2 cm) horizontally apart on a wall or other vertical surface.
The screws should protrude 0.25 in. (0.6 cm) from the surface of the wall.
Step 2 Remove the rubber feet from the router.
Step 3 Hang the router on the screws, front panel down. This is the appropriate orientation for safe use. See
Figure 4-5.
Figure 4-5 Wall-Mounting the Cisco 1841 Router
Caution If you install the screws in drywall, use hollow-wall anchors (1/8 in. (31.75 cm) by 5/16 in. (79.38 cm))
to secure the screws. If the screws are not properly anchored, the strain of the cables connected to the
router back panel could pull the router from the wall.
1 Wall-mounting features
1 Wall 3 Router
2 Mounting screws
103163
1
2
3
To Next Page
Loading...
