11-6
Cisco 1800 Series Routers (Modular) Hardware Installation Guide
OL-5876-03
Chapter 11 Installing and Upgrading Internal Modules in Cisco 1800 Series Routers (Modular)
Modules Internal to the Cisco 1841 Router
Figure 11-5 Removing a SODIMM
Step 3 Insert the SODIMM into the SODIMM socket, as shown in Figure 11-6.
Figure 11-6 Installing a SODIMM
Step 4 Firmly press the SODIMM into the socket until the spring-loaded clips on the socket snap over the end
of the SODIMM.
Installing an AIM
The Cisco 1841 router has the capability to support a single AIM module. To install an AIM, follow the
procedure given here.
1 Spring-loaded clips 3 SODIMM socket
2 SODIMM
103155
1
2
3
1 SODIMM 3 Spring-loaded clips
2 Insert and rotate into socket.
2
3
103154
1
To Next Page
Loading...
