Cisco 1841 - 3G Bundle Router - Installing a SODIMM

11-5
Cisco 1800 Series Routers (Modular) Hardware Installation Guide
OL-5876-03
Chapter 11 Installing and Upgrading Internal Modules in Cisco 1800 Series Routers (Modular)
Modules Internal to the Cisco 1841 Router
Figure 11-4 Cisco 1841 Interior
Caution Do not, under any circumstances, tamper with or attempt to remove the safety shields protecting the
WIC/HWIC slots and connectors.
Installing a SODIMM
You can install a SODIMM to increase the amount of DRAM in the router.
To install a SODIMM on the router motherboard, follow these steps:
Step 1 Locate the SODIMM socket on the motherboard.
Step 2 Remove any existing SODIMM by gently pulling the spring-loaded clips on the end of the socket far
enough to clear the SODIMM, and gently pulling the SODIMM up and away from the socket. See
Figure 11-5.
1 Ground screw 7 AIM module
2 Interface card slot 0 8 SODIMM socket
3 USB port 9 Power supply connection
4 CompactFlash memory card slot 10 System fan
5 Interface card slot 1 11 Power supply
6 Safety shields for WIC/HWIC slots and
connectors
10
7
1
2
3
4
5
6
8
9
11
15
6
95906