4-6
Cisco 1800 Series Routers (Modular) Hardware Installation Guide
OL-5876-03
Chapter 4 Chassis Installation Procedures for Cisco 1800 Series Routers (Modular)
Setting Up the Chassis
Chassis Grounding
After the router has been installed, you must connect the chassis to a reliable earth ground. For the
chassis ground connection procedure, see the
“Wall-Mounting the Cisco 1861 Integrated Services
Router” section on page 4-8.
Wall-Mounting the Chassis
The Cisco 1841 router and the Cisco 1861 ISR can be mounted on a wall.
Warning
This unit is intended to be mounted on a wall. Please read the wall mounting instructions carefully
before beginning installation. Failure to use the correct hardware or to follow the correct procedures
could result in a hazardous situation to people and damage to the system.
Statement 248
Wall-Mounting the Cisco 1841 Router
To mount the Cisco 1841 router on a wall, use two number six, 3/4-inch screws and the mounting features
on the bottom of the router. You must provide the screws. We recommend using pan-head or round-head
screws.
The wall-mounting features on the router are shown in Figure 4-4.
Figure 4-4 Wall-Mounting Features on the Cisco 1841 Router
103162
1
6.00 inches
To Next Page
Loading...
