4-10
Cisco 1800 Series Routers (Modular) Hardware Installation Guide
OL-5876-03
Chapter 4 Chassis Installation Procedures for Cisco 1800 Series Routers (Modular)
Setting Up the Chassis
Figure 4-9 shows the brackets in the rack-mount kit for the power supply.
Figure 4-9 Brackets for Rack-Mounting Power Supply
Step 2 Position the power supply in the wall-mount bracket.
a. Orient the front and back of the power supply vertically.
b. Position the end nearest the power cable at the top.
Step 3 Assemble the brackets for rack-mounting the power supply as shown in Figure 4-10, using the four
screws provided. Use a number 2 Phillips screwdriver to install the bracket screws.
Figure 4-10 Assembling Rack-Mount Kit for the Power Supply
To mount the chassis and power supply, use two screws for each side (supplied with the rack) to attach
the Cisco
1861 ISR with rack-mount brackets, then attach the power supply with rack-mount bracket to
a 19-in. rack. Start the lower pair of screws first, resting the brackets on the lower screws while you insert
the upper pair of screws.
1 Wall-mount bracket 2 Rack-mount bracket
242659
1
2
242661
To Next Page
Loading...
