EasyManuals Logo

Cisco 3900 series User Manual

Cisco 3900 series
226 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #131 background imageLoading...
Page #131 background image
4-3
Cisco 2900 and 3900 Series Hardware Installation
OL-18712-01
Chapter 4 Configuring the Router
Powering up the Router
Note Cisco recommends using Cisco Configuration Professional Express to perform the initial
configuration on the router because it provides a web-based graphical-user interface. See Cisco
Configuration Professional Express, page 4-3.
Cisco Setup Command Facility, page 4-3
Cisco Command Line Interface, page 4-3
Cisco Setup Command Facility
Cisco Setup Command Facility lets you configure the initial router settings through a configuration
dialog. If you see the following messages, the router has booted and is ready for initial configuration
using the setup command facility.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
See the “Performing the Initial Configuration on the Router” section on page 4-4 for additional
information.
Note If the system configuration dialog message does not appear, a default configuration file was
installed on the router prior to shipping. See the “Using Cisco Configuration Professional
Express” section on page 4-8 to configure the router.
Cisco Configuration Professional Express
Use the Cisco Configuration Professional Express web-based application to configure the initial router
settings. See the Cisco Configuration Professional Express User Guide document on Cisco.com for
detailed instructions,
http://www.cisco.com/en/US/docs/net_mgmt/cisco_configuration_professional_express/version1_1/on
line_help/CCPE11.pdf
Cisco Command Line Interface
Cisco Command Line Interface (CLI) lets you configure the initial router settings manually. If you see
the following messages, the router has booted and is ready for initial configuration using the CLI. For
how to use the CLI to configure the router, see the “Using Cisco IOS CLI—Manual Configuration”
section on page 4-8.
Note If the rommon 1> prompt appears, your system has booted in ROM monitor mode. For information on the
ROM monitor, see Using the ROM Monitor in the router’s software configuration guide.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 3900 series and is the answer not in the manual?

Cisco 3900 series Specifications

General IconGeneral
BrandCisco
Model3900 series
CategoryNetwork Router
LanguageEnglish

Related product manuals