3-6
Cisco 2900 and 3900 Series Hardware Installation
OL-18712-01
Chapter 3 Installing and Connecting the Router
Installing the Router
Figure 3-2 Bracket Installation for Back Mounting
Figure 3-3 shows how to attach the brackets to the sides of the router with center mounting.
Figure 3-3 Bracket Installation for Center Mounting
Attaching Rack-Mount Brackets to Cisco 2911, Cisco 2921, and Cisco 2951 Routers
Attach the mounting brackets to the router chassis as shown in Figure 3-4 through Figure 3-7, using the
screws provided.
Caution Do not over torque the screws. The recommended torque is 15 to 18 inch-lb (1.7 to 2.0 N-m).
Attach the second bracket to the opposite side of the chassis. Use a number-2 Phillips screwdriver to
install the number-8 bracket screws.
Caution Your chassis installation must allow unrestricted airflow for chassis cooling.
DO NOT REMOVE DURING
NETWORK OPERATION
DO NOT REMOVE DURING
NETWORK OPERATION
250967
1
2
4
SYS ACT POE
Cisco 2900 Series
To Next Page
Loading...
