2-11
Cisco Video Surveillance 4300 and 4500 High-Definition IP Cameras User Guide
OL-19609-04
Chapter 2 Getting Started
Resetting the IP Camera
Table 2-4 Resetting the IP Camera
Reset Type Procedure Remarks
Reboot. Press and immediately release
the Reset button.
This action is equivalent to
powering the IP camera down
and then powering it up. Settings
that are configured for the IP
camera are retained.
Factory reset. Press and hold the button for at
least 15 seconds.
Sets all IP camera options to
their default values. After you
perform this procedure, follow
the steps in the “Performing the
Initial Setup of the IP Camera”
section on page 2-5.
To Next Page
Loading...
Need help?
General
