Preparing for Installation
• Safety Recommendations and Warnings, on page 1
• Safety with Electricity, on page 1
• Site Requirements, on page 2
• Mounting Requirements, on page 4
• Power Guidelines and Requirements, on page 4
• Network Cabling Specification, on page 5
• Required Tools and Equipment, on page 5
Safety Recommendations and Warnings
Please read the following safety guidelines before you install this product:
• Review the safety warnings listed in Regulatory Compliance and Safety Information for the Cisco 5400
Enterprise Network Compute System before installing, configuring, or maintaining the device.
• Keep the chassis area clean and dust-free during and after installation.
• Keep the chassis in a safe place when you remove the chassis cover.
• Do not wear loose clothing that could get caught in the chassis.
• Wear safety glasses when working under conditions that might be hazardous to your eyes.
• Do not perform any action that creates a hazard to people or makes the equipment unsafe.
Safety with Electricity
Follow these general guidelines when working on equipment that is powered by electricity:
• Locate the emergency power-off switch in the room in which you are working. If an electrical accident
occurs, you can quickly turn off the power.
• Disconnect all power before doing the following:
• Installing or removing a chassis.
• Working near power supplies.
Preparing for Installation
1
To Next Page
