To Next PageTo Next PageWhat to do if there are major events in Cisco Network Router firewall module?
If you are encountering major or severe events in the firewall module processes of your Cisco Network Router, you can use the debug trifecta command.
Why does my Cisco Network Router SIP transition repeatedly from on to off?
The SIP might be booting up, which is normal. Wait 30 seconds until the boot process completes and the STATUS LED stays on. If the SIP does not go beyond the bootup stage, follow the recommended action for the displayed error message. Another possible cause is that the SIP FPGA is not up to date. In this case, follow the system prompts to update the FPGA image. If the SIP is cycling because of an FPD problem, the most likely cause is a FPD failure or that the FPD package file is not present.
General| Category | Network Router |
|---|---|
| Port Density | Varies by module |
| Interfaces | Gigabit Ethernet, 10 Gigabit Ethernet |
| Redundancy | Power supplies |
| Power Supply | AC or DC, Redundant options available |
| Operating System | Cisco IOS XR |
| Management | CLI, SNMP |
| Form Factor | Modular |
| Dimensions | Varies by chassis model |
| Weight | Varies by chassis model and configuration |
| Chassis Slots | 6, 9, or 13 |
