viii
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
OL-10100-04
Preface
Document Organization
Document Organization
This document is organized as follows:
Document Conventions
This document uses the following conventions:
Caution Means reader be careful. You are capable of doing something that might result in equipment damage or
loss of data.
Note Means reader take note. Notes contain helpful suggestions or references to materials not contained in
this document.
OL-10100-02 February 2007 Added information about the Route Switch Processor 720 (a new
supervisor engine) introduced in Cisco
IOS Release 12.2SRB.
OL-10100-01 May 2006 Initial release of the document.
Table 1 Document History (continued)
Revision Date Change Summary
Chapter Title Description
Chapter 1 Cisco 7600 Product
Overview
Provides an overview of Cisco 7600 series routers, and
interface and port addresses.
Chapter 2 Route Switch Processors
and Supervisor Engines
Describes the route switch processors (RSPs) and
supervisor engines supported on Cisco
7600 series routers.
Chapter 3 Installing and Configuring
Route Switch Processors
and Supervisor Engines
Provides instructions for installing and removing RSPs
and supervisor engines and connecting to the console
and uplink ports.
Appendix A Technical Specifications Lists the technical specifications for the RSP and
supervisor engines.
Appendix B Cable and Connector
Specifications
Lists the cable and connector specifications for the
RSPs and supervisor engines.
Convention Description
boldface font Commands, command options, and keywords are in boldface.
italic font Command arguments for which you supply values are in italics.
To Next Page
Loading...
Need help?
General
