Cisco 7600 Series Guide

Contents
iv
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
OL-10100-04
Supervisor Engine 2 2-14
CHAPTER 3 Installing and Configuring Route Switch Processors and Supervisor Engines 3-1
Preparing for Installation or Removal 3-1
Safety Precautions for Module Installation and Removal 3-2
Preventing Electrostatic Discharge Damage 3-2
Tools Required for Module Installation 3-3
Determining Module Location 3-3
Installing a Supervisor Engine or Route Switch Processor 3-4
Removing a Supervisor Engine or Route Switch Processor 3-7
Hot Swapping (OIR) Modules 3-8
Removing and Replacing Memory 3-8
Connecting to the Console Port 3-9
Connecting a Terminal 3-9
Connecting a Modem 3-10
Connecting to the Uplink Ports 3-10
Using Flash Memory Cards 3-12
Installing a Flash Memory Card 3-13
Removing a Flash Memory Card 3-14
Power Management and Environmental Monitoring 3-14
Determining Software Feature Support 3-14
Configuring a Supervisor Engine or Route Switch Processor 3-14
APPENDIX A Technical Specifications A-1
Module Specifications A-1
Regulatory Standards Compliance A-1
APPENDIX B Cable and Connector Specifications B-1
Limiting Connection Distances B-1
Uplink Port Transceiver Modules B-2
1GE Uplink Ports and Cabling Specifications B-3
10GE Uplink Ports and Cabling Specifications B-5
GBIC Module Cabling Specifications B-6
Console Port Cabling Specifications and Pinouts B-6
Console Port Cabling Specifications B-6
Console Port Signals and Pinouts B-7

Cisco 7600 Series Specifications

General

Category	Network Router
Port Density	Varies by module
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet
Redundancy	Power supplies
Power Supply	AC or DC, Redundant options available
Operating System	Cisco IOS XR
Management	CLI, SNMP
Form Factor	Modular
Dimensions	Varies by chassis model
Weight	Varies by chassis model and configuration
Chassis Slots	6, 9, or 13