Using a Handset, Headset, and Speaker
Cisco Unified IP Phone 7906G and 7911G User Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP) 1
Using a Handset, Headset, and Speaker
The Cisco Unified IP Phone 7906G and 7911G provide a speaker for hands-free listening. When you
use the speaker, you can hear the conversation but cannot talk because the phone does not contain a
built-in microphone. To talk on a call, you must use the handset.
You can use the speaker in one of two ways, depending on how your system administrator enables the
phone. Your phone may be enabled for one of the following features, but not both at the same time:
• Group Listen
• Monitor (default)
Using the Group Listen Feature
The following table shows how you can use the Group Listen feature.
If you want to... Then...
Use the handset Lift it to go off-hook; replace it to go on-hook.
Talk using the handset and listen
on the speaker at the same time
(Group Listen)
Press GListen.
Note
Group Listen must be enabled by your system administrator
for the GListen softkey to display.
Turn off Group Listen and use the
handset
Press GLOff.
Hang up after using Group Listen Press EndCall or hang up.
Adjust the volume level for a call
Note
When using Group Listen, adjusting the volume only
changes the volume for the speaker and not the handset.
Press the up or down Volume button during a call or after
invoking a dial tone.
Press Save to preserve the volume level for future calls.
To Next Page
Need help?
General
