To Next Page

To Previous Page

2 OL-22336-01

Using the Monitor Feature

The following table shows how you can use the Monitor feature.

Tips

• If your system administrator has disabled the speaker on your phone, the GListen, GLOff,

Monitor, and MonOff softkeys will not be available to you. You must lift the handset to place and

monitor calls.

• Pressing the Volume button changes the volume for the handset or speaker, depending on which

device is in use. In Group Listen and Monitor modes, the volume adjustment is for the speaker

and not the handset.

Note If you need to change the wideband setting for your handset (for example, if you change your

handset) press

and choose Settings > User Preferences > Audio Preferences > Wideband

Handset. If the Wideband Handset setting shows as dimmed, then this setting is not user

controllable.

Check with your system administrator to be sure your phone system is configured to use

wideband. If the system is not configured for wideband, you may not detect any additional

audio sensitivity even when using a wideband handset. To learn more, refer to the handset

documentation or ask your system administrator for assistance.

If you want to... Then...

Use the handset Lift it to go off-hook; replace it to go on-hook.

Listen to the call on the speaker Press Monitor and then hang up the handset. You will be able to

hear the call but you will not be able to talk on the call.

Note The Monitor and MonOff softkeys are not available if

Group Listen is enabled.

Turn off the speaker and use the

handset

Lift the handset, or press MonOff.

Note

The Monitor and MonOff softkeys are not available if

Group Listen is enabled.

Turn off the speaker and hang up Press EndCall.

Adjust the speaker volume level

for a call

Press the up or down Volume button during a call or after

invoking a dial tone.

Press Save to preserve the volume level for future calls.

Cisco 7906G Instructions For Use

Other manuals for Cisco 7906G