Cisco 7906G Instructions For Use

Using a Handset, Headset, and Speaker
Cisco Unified IP Phone 7906G and 7911G User Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP) 3
Using a Headset
To use a headset, disconnect the handset and connect a headset to the Handset port. For information
about purchasing headsets, see Headset Support, page 3.
Using Wideband with your Headset
If you connect a headset to the handset port, be sure that the Wideband Handset setting is disabled.
Choose User Preferences > Audio Preferences > Wideband Handset.
Note If the Wideband Handset setting shows as dimmed, then this setting is not user controllable
and you must contact your system administrator to change this setting.
Using AutoAnswer
When AutoAnswer is enabled, your phone answers incoming calls automatically after a few rings.
Your system administrator can configure AutoAnswer to use the speaker to answer calls. However,
you can only monitor the call using the speaker. To talk to the caller, you must pick up the handset.

Cisco 7906G Specifications

General

Brand	Cisco
Model	7906G
Category	IP Phone
Language	English