11
Securing the Phone with a Lock Set and Cable Lock
You can secure the Cisco Unified Wireless IP Phone 7925G to a desktop by ordering the lock set from us. For more information,
see the Cisco Unified Wireless IP Phone 7925G Accessory Guide.
To install the lock set, use the diagram and follow these steps:
Install the Lock Set on the Phone
1. Insert the loops at the ends of the security cable through the C-ring.
2. Insert the C-ring with cable loops through the slot on back of phone.
3. Use the combination lock to secure the ends of the C-ring around cable loops and phone.
Out-of-Range Alerts
Your system administrator can configure your phone to send you an audible alert (beep) when you are out of range of the
wireless network. When you hear the alert, the (no signal) icon displays on the phone screen.
When you are out of range of the wireless network, you are not able to use the phone for features requiring a wireless network
connection, such as making and receiving calls.
If your system administrator enabled the out-of-range alert, depending on the configuration, you might hear a beep only once,
or every 10, 30, or 60 seconds until you are back within the range of the wireless network.
To reconnect to the wireless network after you hear the alert, move to another location until you see the signal icon on
the phone screen again.
To Next Page
Loading...
Need help?
General
