1-4
Cisco 800 Fast Step Software Design Guide
OL-10373-02
Chapter 1 Introduction to Design
Configuration Scenarios
Configuration Scenarios
Cisco 800 Fast Step Setup provides a limited number of configuration scenarios that can be built using
the Setup wizard or a CFG file and performs comprehensive testing for each scenario, as opposed to a
Cisco 800 Fast Step IOS template (TPL), which can configure any scenario because Setup does not test
TPL configurations. A summary of Setup’s capabilities is shown in Table 1-1.
Table 1-1 Cisco 800 Fast Step 2.3 Support
Section Support
WAN Support
T1/E1 leased line.
Frame Relay PPP
1
.
ISDN BRI
2
(supports PPP).
Serial connections on Cisco 805 series router. Supports PPP, Frame Relay, and
HDLC.
POTS
3
on Cisco 802 and Cisco 804 series routers.
1. Point-to-Point Protocol (PPP)
2. Basic Rate Interface (BRI)
3. basic telephone service (POTS)
Connection Support
Two connections maximum.
IP and IPX only.
Dual connection to a corporate network (requires that RIP
4
is on at the central
site).
4. Routing Information Protocol (RIP)
Firewall Support
Always uses PAT
5
and NAT
6
for connection to the Internet.
Allows publication of Web, mail, or FTP
7
servers on the Internet when the
servers are on a single LAN.
5. Port Address Translation (PAT)
6. Network Address Translation (NAT)
7. File Transfer Protocol (FTP)
To Next Page
Loading...
