4-6
Cisco 800 Fast Step Software Design Guide
OL-10373-02
Chapter 4 Custom Software Installation
Web Site Support
Web Site Support
The Cisco Fast Step_Reset.exe program launches a Web browser and points to the Registration and
Welcome Web sites of the service provider.
Registration Web Site
The registration Web site launches a local Web page. The path is relative to the Cisco 800 Fast Step
installation directory. A Web browser must be installed, and it is automatically launched as a separate
program. The following is an example of the flag in the CFG file:
[Belle Systems]
ISPSetupURL=http://test.cisco.com
Welcome Web Site
The Welcome Web site displays after the router has been registered and configured through Belle
Systems IMS+. The path is relative to the Cisco 800 Fast Step installation directory. A Web browser
must be installed, and it is automatically launched as a separate program. The following is an example
of the flag in the CFG file:
[Belle Systems]
ISPLocalURL=http://www.cisco.com
Service Provider Instructions to End Users
The procedures in this section describe loading a CFG file and a TPL file for the end user. Although it
is likely that you will modify these instructions for individual use, they provide a starting point.
End-User Instructions for CFG Files
Complete the following procedure to load a router configuration by using a Cisco 800 Fast Step CFG
file:
Step 1 Cable the router as described in the Cisco 800 Fast Step Quick Reference Guide.
Step 2 Locate the instruction sheet that lists the parameters you will need to configure the router.
Step 3 Install Cisco 800 Fast Step software on a PC attached to the router by a configuration cable or connected
to the same Ethernet LAN.
Step 4 Launch Cisco 800 Fast Step Setup. The Welcome window displays.
Step 5 Click Next. The Service Selection window displays.
To Next Page
Loading...
