4-8
Cisco 800 Fast Step Software Design Guide
OL-10373-02
Chapter 4 Custom Software Installation
Service Provider Instructions to End Users
• Add your service provider CFG and TPL files to the new country folder. They will automatically
display in Service Selection window under the specified country.
• Refresh the Service Selection window by moving back to the Welcome window and clicking Next
to display the Service Selection window.
Step 7 Verify that the configuration file is shown in the Service Provider list. If the file is not shown in the
field, do one of the following:
• Click Update or Add Service File to load a configuration file from another drive or directory.
Follow the on-screen instructions to select the file, and continue with Step 8 in this procedure.
• Select Connect to an unlisted service provider or corporate network, and click Next to use the
wizard to build the router configuration. Follow the on-screen instructions to complete the
configuration.
Step 8 Click Next to continue, and follow the on-screen instructions to complete the configuration.
End-User Instructions for TPL Files
Complete the following procedure to load a router configuration before using a Cisco 800 Fast Step IOS
template (TPL) file:
Step 1 Cable the router as described in the Cisco 800 Fast Step Quick Reference Guide.
Step 2 Locate the instruction sheet that lists the parameters you will need to configure the router.
Step 3 Install Cisco 800 Fast Step software on a PC attached to the router by a configuration cable or connected
to the same Ethernet LAN.
Step 4 Launch Cisco 800 Fast Step Setup. The Welcome window displays.
Step 5 Click Next. The Service Selection window displays.
Step 6 Verify that your country is shown in the Country field. If your country is not shown in the field:
• Go to Windows Explorer, and add your country name as a folder under the ServiceProvider
directory. The country names are listed in Table 4-1.
• Add your service provider CFG and TPL files to the new country folder. They will automatically
display in Service Selection window under the specified country.
• Refresh the Service Selection window by moving back to the Welcome window, and click Next to
display the Service Selection window.
Step 7 Verify that the TPL file is shown in the Service Provider list. If the file is not shown in the field:
• Click Update or Add Service File to load a TPL file from another drive or directory. Follow the
on-screen instructions to select the file, and continue with Step 8 in this procedure.
• Select Connect to an unlisted service provider or corporate network, and click Next to use the
wizard to build the router configuration. Follow the on-screen instructions to complete the
configuration.
Step 8 Click Next to continue. The Template File Field Entry window displays.
Step 9 Complete the configuration by entering the values as shown on the instruction sheet.
Step 10 Click Next, and follow the on-screen instructions to complete the configuration.
To Next Page
Loading...
