Disconnect Optical Ports from the Network
When you need to remove fiber-optic transceivers, you must first remove the fiber-optic cables from the
transceiver before you remove the transceiver from the port.
Maintain Transceivers and Optical Cables
Refer to Inspection and Cleaning Procedures for Fiber-Optic Connections document for inspection and cleaning
processes for fiber optic connections.
Verify Chassis Installation
After installing the chassis, use the following show commands to verify the installation and configuration in
the EXEC mode.If you detect any issues, take corrective action before making further configurations.
DescriptionCommand
Displays the operational status of the node.show platform
Displays information about the field replaceable units (FRUs), including product IDs, serial numbers,
and version IDs.
show inventory
Displays all the environment-related router information.show environment
Hardware Installation Guide for Cisco 8200 Series Routers
35
Connect Router to the Network
Disconnect Optical Ports from the Network
To Next Page
Loading...
Need help?
General
