3
1 About this Guide
This guide provides instructions on how to install and configure your Cisco Aironet 1830 Series Access
Point. This guide also provides mounting instructions and limited troubleshooting procedures.
The 1830 Series Access Point is referred to as the access point, or abbreviated as AP in this document.
2 About the Access Point
The Cisco Aironet 1830 series access point is an 802.11 a/b/g/n/ac (Wave 2) access point, with internal
antennas only. The access point can be mounted on a wall or a ceiling, and supports 2.4 GHz 3x3
802.11b/g/n MIMO and 5 GHz 3x3 802.11 a/n/ac (Wave 2) MIMO applications simultaneously.
Access Point Model Numbers and Regulatory Domains
The Cisco Aironet 1830 series access point comes in both universal regulatory domain and
non-universal regulatory domain model number formats. See the following table for the model number
formats.
The ‘UX’ in a model number indicates a universal regulatory domain access point. For information on
how to set the regulatory domain and country configurations of a universal regulatory domain access
point, see the Cisco Aironet Universal AP Priming and Cisco AirProvision User Guide, at:
http://www.cisco.com/c/en/us/td/docs/wireless/access_point/ux-ap/guide/uxap-mobapp-g.html
The ‘x’ placeholder in the other model numbers represents the regulatory domain. The ‘x’ can be any
one of these supported regulatory domains: A, B, C, D, E, F, H, I, K, N, Q, R, S, T, Z.
For more information on supported regulatory domains, see the following page:
http://www.cisco.com/c/en/us/products/collateral/wireless/access-points/product_data_sheet0900aecd
80537b6a.html
Universal Regulatory Domain
Model Number Format
Non- Universal Regulatory
Domain Model Number Format
Models Numbers AIR-AP1832I-UXK9
AIR-AP1832I-UXK9C
AIR-AP1832I-x-K9
AIR-AP1832I-x-K9C
To Next Page
Loading...
Need help?
General
